Shaking Incubator are widely used in Chemical labs, Pharmaceutical division, Biotech, Fertilizer division, R&D & QC divisions, Microbiology, and Clinical trial labs.
STANDARD MODELS
Model no.
TRAY SIZE
in mm
RPM range
Shaking Dia.
Temp. range
No. Of Clamps to hold flask
SGS-19 SI01
420 x 420
50 – 250 rpm
25mm
5°C above ambient to 60°C
Without cooling
Lotus clamps
250ml – 16
Or
500ml - 16
SGS-19 SI02
10°C to 60°C
With cooling
*Shaking Incubator also available in different sizes as per customer requirements.
Standard Specification
Model
Table top type
Temperature range
5°C above Ambient to 60°C / 10°C to 60°C
Temperature control
+ 0.1°C / 0.01°C
Temperature Uniformity
Better than + 1°C
Ambient Temp. Recommendation
Ambient
Display Resolution & Control Sensitivity
0.1°C / 0.01°C
Control Readout
Actual and Set point
Controller
Digital Microprocessor based PID
Sensor
Pt 100 (RTD)- 3 wire
Timer
Digital timer with- hour / min / sec., & continuous operation selectable
Shaking speed
Indicated by Digital RPM indicator
Shaking speed range
50 – 250 rpm
Shaking accuracy & Diameter
+ 1% & 25mm dia.
Mechanism drive
Through PMDC motor with DC drive
Insulation
PUF – poly urethane foam
High temperature cut off
2.0°C
Heating
Stainless steel air heater to control set point
Alarm type
Deviation High or Low
Inner Chamber
Stainless steel 304 grade dully polished
Outer
Mild steel CRCA sheet with powder coating
Door
Fully front opening , Double walled, inner lined with SS, Handle & Lock
Gasket
Magnetic type
Viewing window
Through toughened glass
Cooling
CFC free single stage refrigeration system for below ambient
Refrigerant
R134a
Compressor
Hermetically sealed Emerson make
Condensor
Fin and tube air cooled type
Lighting attachment
Low wattage PL lamp to view samples
Power supply
Single Phase – 230VAC, 50Hz
Optional features
NABL Certified Calibration Certificate
Fully stainless steel
Note: For continuous development the above technical specification & design, SGS reserves rights to change without any prior notice.